Hello.
A lot of time was invested in models and FDE's to get apearance & performance very close to real. The intention is when you fly these models it would be like the real plane.
Comments and suggestions are welcome. Any doubt, e-mail to narcizo@linhalivre.net and I will sure reply.

Thanks to:
- Denis da Silva who was my consultant when I began with FSDS.
- A. C. Lucena for FDE analisys and test flights.
- Eliezer Rice for improvements and the beauty panel.

How to install this model:
- Unzip the files in a temporary folder with the option "use folder names" tagged;
- check to be sure the sub-folders - model, panel, texture, sound - were created;
- move the entire temporary folder to your FS aircraft folder.
- check again the new folder created.
Start Flight Simulator and search for your new airplane. If it doesn't appear on list, set ANY on AIRCRAFT MANUFACTURER tag (maybe the manufacturer name is a little different of others you have - to correct this, open the aircraft.cfg and change the line ui_manufacturer= to the same name you want to appear).

How to fly this model:
TAKE-OFF:
- maintain a little press to front in stick to acquire a horizontal attitude;
- at 60 mph pull the stick to leave the ground;
- set the throttle to 2,200 rpm. Maintain 65/70 mph while climbing to the cruise level. The initial rate is around +700 fpm.

CRUISE:
- 100 mph IAS at 5,000 ft, rpm=2,100 (longest range)
- 105 mph IAS at 5,000 ft, rpm=2,200

LANDING:
- Decrease speed to 65 mph and set flaps to 10 degrees;
- set throttle to 1,500 rpm;
- at short final approach, flaps to 20 or full.

FEATURES:
- Full flyable Virtual Cockpit.
- Reflexive texture in windshields.
- Shift+e 1 open/close front canopy
- Shift+e 2 open/close rear canopy

PANEL:
- The panel included is the PT-19 model. If you are a panel maker, please rebuild it and upload to free FSim sites.

Thanks for downloading my model.

J.E.Narcizo

----------------------------------------
REPAINTS:
You are welcome to repaint to this model as long as they remain freeware.
----------------------------------------
LEGAL WARNING
Copyright: RanchoJEN models - Brazil
This software is FREEWARE - you don't have to pay nothing for it.
Any commercial use (including upload to a pay-to-enter site and any other use in wich a money exchange is involved) IS PROHIBITED without the author permission.
Also any repacking, reworking or any kind of manipulation of these files is not allowed.

All models by RanchoJEN have a little LOGO on right side of fuse, under the vertical stabilizer.
----------------------------------------